Description

The following refers to: 3DPX-013306 The FDA has authorized production of protective face shields outside of the normal clearance pathway during the COVID-19 pandemic, based on Part 5, section D of the “Enforcement Policy for Face Masks and Respirators During the Coronavirus Disease (COVID-19) Public Health Emergency Guidance for Industry and Food and Drug Administration Staff." This face shield has undergone review in a clinical setting and is recommended when fabricated as instructed. There is a shortage of protective gear for doctors and nurses, so 3DVerkstan designed a frame for holding standard sized plastic sheets. Quick to print, easy to assemble. Using readily available plastic sheets with as little modification as possible, and only common tools used. All features printable with nozzle sizes up to 1mm and layer heights up to 0.5mm Drip protection above the eyes Printable in less than 20 minutes No tight tolerances requiring well-tuned printers. Design that works equally well with most common materials (PLA, CPE, PETG, ABS etc.) The visor is tested and approved by staff all over the world but there are a lot of different regulations regarding medical supplies, please make sure to follow authority guidelines that applies within your region. This model has been approved by Columbia University Medical Center/New York-Presbyterian Hospital staff, who are currently using hundreds of them. More information can be fonud at the designers web site: https://3dverkstan.se/protective-visor/ (https://3dverkstan.se/protective-visor/) You can also find the files and lisence here: https://github.com/Cederb/Faceshield.nu/ (https://github.com/Cederb/Faceshield.nu/)